AT15 LFE (Light-weight Flash Eliminator)

5 5 2 Product
$115.00
Choose options from dropdown list(s) below
AT15 LFE

+

Our newest flash hider/compensator is designed both to eliminate flash on the shorter barreled ARs but also to compensate for muzzle climb.
It is available with 1/2X28 TPI for rifles in 223/5.56 as well as with 5/8X24 TPI for rifles in 300 Blackout.

Weight: 3.5oz
Outer Diameter: .865"
Length: 2.25"

Here's a video to see the LFE
(and Eliminator) in action

 

 

Installation Instructions:
Ensure firearm is UNLOADED and SAFE before proceeding!


Tools required
-¾”open ended wrench or adjustable crescent type wrench
-Anti-seize or other heavy grease
-Electrical tape (optional)
-Method to hold barrel or receiver

  Remove any existing device from barrel. Note- many firearms may have factory installed muzzle devices pinned or welded on.
   If you are not sure how to remove the device without damaging the firearm or
muzzle threads, stop and consult a gunsmith.

Once the existing device has been removed, inspect and clean muzzle threads. Apply a small amount of anti-seize or heavy grease to the exposed muzzle threads. Place the enclosed crush washer on the muzzle so that the flared side of the washer faces toward the LFE. Ensuring it is not cross threaded, carefully hand screw the LFE onto the muzzle until it is hand tight on the crush washer. The supplied crush washer will allow the LFE to be tightened approximately 1/2turn. If the LFE is more than 180 degrees from 12 o'clock, remove the LFE, flip the washer over and reassemble.

Secure the barrel or receiver from turning utilizing an approved method.

With a ¾” open ended or an adjustable wrench, tighten the LFE until the "T" is at Top Dead Center (12o'clock). Hint: If using an adjustable wrench, wrap a couple of layers of electrical tape to avoid marring the finish of the LFE.

Note-In order  to provide maximum effective muzzle control, the LFE is required to be "timed". Optimal timing is achieved when the engraved “T” (Top) is in the 12 o'clock position. When the LFE has been tightened, the "T" will be pointing in line with the vertical axis of the firearm. Wrench flats will be on top and bottom when tightened.

 


Please login to post comments

Cart

The cart is empty